This is a Bath toy set featuring water Pokemon from Kanto. We have two children under the age of 6 who love pokemon, and knowing there would be a bathroom print contest, it seemed like the perfect time to design bath toys! most of the things we print for them wind up in the tub at somepoint.

Each one in this set has a different function - some are obvious but one, maybe not so much.

MAGIKARP GO! USE SPLASH!!

These are just little floaties - if you make sure to have at least 6 bottom layers (You will need more if he is resized), they will float in proper position (or upside down) instead of on his side. The 3MFs already have it set to 6 bottom layers.

GYARADOS GO! USE BITE!!

This is a bathtub scoop - just hold the handle and scoop up whatever is floating on the water, like the Magikarp floaties. This could probably be printed without supports; but I did not bother to try. One support inside his mouth holds the tail up. It is already set up on the 3MFs.

SLOWPOKE GO! USE RAIN DANCE!!

It might not be a gen 1 move, but this slowpoke will make it rain! Completely submerge it in water, when it is no longer bubbling, grip the top stem between your fingers and cover the hole with your thumb well. Lift and re-cover the hole with your thumb to make it rain. No supports.

HORSEA GO! USE BUBBLE! USE WATERGUN!!

This one can be played with in a few different ways. If you dip Horsea's nose in a cap full of bath bubble solution (or dish soap) mixed with a little water and blow gently - it will bubble. Or you can spit water instead if you blow water forcefully through it. No supports.

SEEL GO! USE WATERFALL?

Seel can be filled with water and poured out. But if you fill/empty it to a certain point it will make loud gurgling GLUG GLUG noises when you swing it back and forth as the water and air swishes around in it. To get to this it is easiest I find to fill it up and slowly pour water out until it starts to make noise on the pour. Tip it back up and give it a little swing. If you don't hear much pour a little more water out, and try again until it reaches the GLUG GLUG noises. Supports are already set up on the 3MF for his tail.

As always, slow down the outer layer for a nicer looking print, the bottom overhangs can also be supported for a nicer finish, but I found that as these are bath toys the function was not interrupted.

The Bathroom Pokemon Sign is in this file set as well! It requires an AMS and prints Facedown.

Thank you for checking out my Bathset!