Occupancy DoorSign

Occupancy DoorSign

Boost
14
29
5

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.16mm layer, 2 walls, 15% infill
0.16mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
4.2(5)

Open in Bambu Studio
Boost
14
29
5
1
48
24
Released

Description

Do you need a sign on the door?

You might think that a "vacant" or "occupied" sign on a restroom or meeting room door is unnecessary. However, there are several reasons why such a sign can be very helpful.

First, it can help people avoid awkward situations. Imagine walking into a restroom that you thought was empty, only to find someone already using it. An "occupied" sign can prevent this from happening.

Second, it can help people save time. If you're looking for a meeting room, you don't want to waste time checking each door to see if it's empty. An "occupied" sign can let you know at a glance if a room is available.

Finally, it can help people be more efficient. If you know that a restroom is occupied, you can go to a different one instead of waiting. This can help you get back to work or whatever else you need to do more quickly.

In conclusion, there are several good reasons to put a sign on a restroom or meeting room door to indicate whether the room is occupied. Such a sign can help people avoid awkward situations, save time, and be more efficient.


Assembly:

1. Put the slider piece into the two-colored display piece.

2. Slide the display piece into the frame. It should have a tight fit.

3. Move the slider left and right a couple of times. Then it will become easier to move.

Comment & Rating (5)

Please fill in your opinion
(0/5000)

Print Profile
0.16mm layer, 2 walls, 15% infill
a little bit tight on the tolerances, and i wish it had a layer or 2 more for the color, but not big problems :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Strength Issue
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Other Issues:I had to change the scale of the parts because it was not fitting together. Also I had to sand it so that it fits.
0
Reply
No more