Pokemon - Tiny Swinub
Pokemon - Tiny Swinub
Print Profile(2)
Description
This little Swinub model is easy to print with no supports or glue required!
The nose push fits into the body and will hold in place with no glue, however take care to orientate it the right way up when inserting.
The eyes will require a small amount of paint or permanent marker for the best results.
Print at a 0.1mm or lower layer height with fuzzy skin enabled for the best results. body and eye models should be printed as a single piece, and are presented here as seperate models for better control over the fuzzy skin settings.
Comment & Rating (0)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
