Wrist rest / Palm rest for Keychron k4v2. Prints in 2 parts so it can fit on non massive printers (each piece is 192mm long
Orientation : would recommend either printing upside down or standing up on its end depending on the texture you want. texture in picture was upside down with concentric top/bottom, on a texture pei sheet.
support is required for the 2 dowels. might be some stringing on the curve of the rest if your cooling isn't good enough.
Printed in PLA+ 205c 100m/s
Printer : Ender 3, BiquH2 hotend, textured PEI sheet