Search models, users, collections, and posts
Drawer Guide
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
1
2
1
0
6
3
Released
Description
Piece broke on the drawer so I printed this out of plastic PETG to replicate the other with a more load bearing angle.
Printed on its back is fine to hold up the weight, but if you want to you can stand it up. It's just a lot harder to print standing up.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)