Gear Stack Pencil Holder / Pot
Copyright Claim
Gear Stack Pencil Holder / Pot
Boost
67
102
15
Print Profile(2)
No brim, Buildplate supports only
Designer
6.5 h
1 plate
A1 Mini Tested - 0.2mm layer, 2 walls, 15% infill
7.1 h
1 plate
Boost
67
102
15
0
151
90
Released
Description
Put your writing utensils in this cool organizer! Or, perhaps use as a planter.
Default size is ~60mm diameter and ~65mm depth - scale as you wish.
Print inverted with top angled gear down on build plate. Supports on build plate only for smoother finish or forgo if you trust your printer's bridging ability.
Comment & Rating (15)
All
Print Profile
No brim, Buildplate supports only
very good print no problems followed directions. changed size to X 100 y 100 and z 85
0
Reply
Print Profile
No brim, Buildplate supports only
great thank you
0
Reply
Print Profile
No brim, Buildplate supports only
Printed great but for some reason I had trouble with the petg pla interface but it holds stuff
0
Reply
Print Profile
No brim, Buildplate supports only
perfect!
0
Reply
Print Profile
No brim, Buildplate supports only
sweet design!
0
Reply
Print Profile
No brim, Buildplate supports only
(Edited)
0
Reply
Print Profile
No brim, Buildplate supports only
printed just fine. Could have been a bit taller, now the pens are falling out a bit too much.
0
Reply
Print Profile
No brim, Buildplate supports only
looks really good. came out great. I’m very happy about it
0
Reply
Print Profile
No brim, Buildplate supports only
Printed without any issues.
0
Reply
Print Profile
No brim, Buildplate supports only
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld