This will restrict your cabinet door from opening past a 90 degree angle. Intended for the Ikea Utrusta 110° hinge used on Sektion cabinets. Aka the “Blum CLIP top BLUMOTION” hinge.
To install: remove the cabinet door, move the hinge to the “closed” position, and insert the restrictor into the gap by the door edge (see the photo above).
Prints pretty easily with all the default settings. PLA works, but PETG or others may resist wear better. Only one is needed per door, but doing both hinges may be more durable. The initial angle is set to less than 90 degrees because it will wear down a lot at first, especially if you open the cabinet hard.
Comment and let me know if you'd like a version with a different angle.