Eclipse Pinhole Projector Paddle
Copyright Claim
Eclipse Pinhole Projector Paddle
Boost
4
12
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
4
12
16
0
100
93
Released
Description
This pinhole projector will allow you to view the eclipse during the partial phase. As the light passes through the holes of the paddle, you'll see crescent shaped projections as seen in the photo.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed a couple of these for the eclipse. worked well.
The designer has replied
0
Reply
Awesome! Thanks for the rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked great, was very fun to watch the shadows change as we waiting for totality! thanks!
The designer has replied
0
Reply
Awesome! Thanks for the rating!
0
Reply
I had to print this on my Sovol SV06 Plus since it was too big for my A1 mini.
It printed well - I was worried about all the little holes but there was no problem.
Worked great, with clear crescent patterns on both a deck and a Labrador.
The designer has replied
0
Reply
Thanks for rating! Glad it worked out for you!
0
Reply
worked great
The designer has replied
0
Reply
Thanks for rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Thanks!
The designer has replied
0
Reply
Thanks for rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints great, yes this is a photo taken with the camera. MW requires a photo for ratings above 3 stars ¯\_(ツ)_/¯
The designer has replied
0
Reply
Hey thanks for rating! Appreciate it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked great, thanks for sharing.
The designer has replied
0
Reply
Thanks for rating!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for rating!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld