X1C Roofed Poop Bucket (Cat Proof)
Copyright Claim
X1C Roofed Poop Bucket (Cat Proof)
Boost
38
50
28
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
Boost
38
50
28
0
142
92
Released
Description
A fully closed poop bucket to avoid my curious cats digging into the bambu poops
- carefully designed to avoid suppot
- a slot to house a square magnet comes with X1C accessories
- front logo face were reduced to 1 layer wall, for poop level inspection
- slim back chute for minimal back space consumption
Comment & Rating (28)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Was a great chute while it lasted. Was pleased it was far less material than a lot of the others. I ran this for a week or two but ended up doing some anti vibration feet that ended up messing with the alignment between the chute and this. I propped it up for a while but think I’m going to find another that won’t require me to prop it up.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
this print is clean and prints really fast! great job!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print was good but a little hard to empty.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Small opening has gotten clogged a couple of times. On one of the occasions it caused a large print job to shift over and I had to restart.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
looks good
0
Reply
realy nice desing
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ame out flawless
0
Reply
Verified cat proof. Printed great without supports. Used tape to secure it to the printer. Works with p1s.
0
Reply
Does this work for the P1S? has any tried this out? just wanted to ask before I tried it out myself and wasted a bunch of filament
0
Reply
printed great and blocks the curious catto’s! nice design!
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld