Side AMS Dryer No Supports
Remixed by
Copyright Claim
Side AMS Dryer No Supports
Remixed by
Boost
82
179
56
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
1 plate
Open in Bambu Studio
Boost
82
179
56
1
485
290
Released
Description
Seen some like this with horizontal bars but they don't print well this is similar to the original design just shrunk down to fit into the two ends of the AMS to add more silica to keep dryer for longer. They are the blue ones in my picture, might just need a funnel to fill without mess but the other ones also need that save getting the beads all over the floor.
Comment & Rating (56)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
This part maintains the aesthetic of the full size pieces and furthers the AMS ability to store desiccant; great print!
*stringing likely due to wet ABS filament
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy print, fits where it's supposed to and the lid is nice and tight so no accidental spills. Thanks!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it works and print perfect
1
Reply
I only used the center desiccant box cause I wanted the hygrometer. Turned out awesome! great print
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
They print and work amazing, printed with a 0.6 Nozzle
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked perfectly for me, with Bambu Basic PLA
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Had to size up the lids .5% to get the to fit. I used PLA. Other than a minor sizing issue that was probably my fault no issues with profile
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works as described
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fits well and works perfectly
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The doesn't fit, too snug
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld