Ridokilos

you can also flip it upside down and use minimal supports

pinionPlus

Yep, i considered that, but wanted any support scarring (there was very little) to happen on the back. In retrospect i probably should have done it the other way still lol

ImOkAtThisGame

X1C Cold Plate 0.16mm layer, 2 walls, 15% Gyroid infill

cover

Majoras_Face_Mask_2020-Apr-24_02-09-26PM-000_CustomizedView315153355_png.png

Majoras_Face_Mask_2020-Apr-24_02-09-48PM-000_CustomizedView1391121032_png.png

20231130_230013.webp

plate_1.png

plate_2.png

plate_3.png

plate_4.png

plate_5.png

In this I've added gratuitous supports for the half-mask itself with some manual support painting. I've also placed the horns all on separate plates (by size) to make sure the Silk PLA that I used has a mostly uniform finish. Confident you could drop it all on fewer plates without issue.&nbsp;The supports are worth it. I know it is a lot, but they come off super clean and the front surface finish is mighty fine. A tiny bit of sagging on the inside at the very top, but nothing terrible (or visible for that matter).&nbsp;Gyroid infill because I hate grid and for a more consistent surface finish.&nbsp;&nbsp;

plate_1.webp

plate_2.webp

I painted the model so it is accurate to the picture.NOT PRINTED YET.&nbsp;

0.16mm layer, MultiColor (5), Tree Suppport

This is a face cover Modeled after Majora's Mask from Legend of Zelda, The file is in 7 pieces. Happy Printing!

Print Profile(2)

Description

Comment & Rating (6)

License

Related Models

Zelda majora's mask

Mesh Eyes for cosplay helmets

uka uka mask

Brick Man - Angry Face (500%)

Majora's Mask Face Cover