I designed this Skadis mounting system because I cut my skadis board in half because the size I needed wasn't available, and the package only came with one mounting rail.
I also didn't like that with a bit of misaligment the board had a seam in the middle, so I designed a part to put between the boards, that forces them into alignment.
What you need per board:
2x 4-5×60-80 mm screws for mounting (depends on what you're hanging on your board)
2x 6-8 mm Concrete or drywall anchor (depends on what you're hanging on your board)
2x M3x8-25 for the spacers (the holes can be tight, you have to force these in)
Printed parts:
2x Mount Edge Back
2x Mount Top
2x Spacer Edge Back
2x Spacer Top
In case you want to connect two boards like i did, you need to add these:
2x 4-5×60-80 mm screws for mounting (depends on what you're hanging on your board)
2x 6-8 mm Concrete or drywall anchor (depends on what you're hanging on your board)
2x M3x8-25 for the spacers (the holes can be tight, you have to force these in)
Printed parts:
1x Mount Middle back
1x Spacer Middle Back
2x Mount Top
2x Spacer Top
Hope you enjoy! :D