Electric Toothbrush Holder (with drain geometry)
Copyright Claim
Electric Toothbrush Holder (with drain geometry)
Boost
30
61
7
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
30
61
7
2
112
53
Released
Description
Philips Sonicare Holder I designed but revised recently, Support free and strong in PETG or PLA
I used double sided tape to mount to my shower wall and drain holes keep my toothbrush from leaving gross rings.
If you use your own print settings, make sure to set the 2nd solid body to have a few more walls than the rest of the model to ensure the chamfer has support further down than just on the surface.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Did a double sided tape. Hope it holds for long
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Very nice print. Quick and without any supports. Printed nicely in green Bambu Lab PLA.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Looks good
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
these are perfect for holding our toothbrush’s
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Simple yet satisfying
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld