Search models, users, collections, and posts
Shower Caddy
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
11.6 h
3 plates
Open in Bambu Studio
Boost
95
188
3
4
204
32
Released
Description
This is a shower caddy I made to fit my shower. It's designed to hang from the shower head coming out of the wall commonly used in the USA. It was designed to be printed on a 300mm x 300mm bed. I think you might be able to scale it to fit and still connect and fit in a shower, but I haven't tried it. I'm going to work on a smaller version that should fit 250 x 250 beds but I'm new to 3D modeling and resizing it started causing me lots of problems that will take me a bit to figure out. I recommend printing all parts in PETG.
NOTE: The only part that needs support is the hanger.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)