Camellia flower
Copyright Claim
Camellia flower
Boost
136
234
43
Print Profile(1)
0.2mm layer, 0% infill, no support
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
136
234
43
8
532
318
Released
Description
The cover page of the book “3D Printed Science Projects” showcases an exquisite camellia flower model. Notably, the petals of this model exhibit an impressive 70-degree overhang.
Kudos to the authors of the book.
Comment & Rating (43)
All
Print Profile
0.2mm layer, 0% infill, no support
Really nice! printed with PLA galaxy.
dont look at the print half way, it looks like the middle will be a mess.. it looks really bad. just wait! in the end it will all work out.
The designer has replied
2
Reply
Thank you for the sharing.
0
Reply
It started off ok but then it randomly started printing in the middle when there was nothing there. Is there a particular way to print it
The designer has replied
0
Reply
this is another picture
0
Reply
Replying to @user_4135515680
Thank you for sharing. This artifact is because complex geometry with 0% infill.
You can try one of the following options:
1. Close your eyes and allow the print to complete; it should turn out fine.
2. Adjust the 0% infill to a 5% lighting or gyroid infill for improved interior support.
3. Use OrcaSlicer, which will create an internal bridge in this model, and get better interier stability.
0
Reply
Print Profile
0.2mm layer, 0% infill, no support
as someone else has said..you definitely need to persevere with this print...at the beginning it does look as if it's gone wrong....but the finished item is lovely. printed on P1p generic plac
The designer has replied
0
Reply
Thank you for the sharing. The middle messy part is a result of having 0% infill. Glad to hear the finish is great.
0
Reply
Print Profile
0.2mm layer, 0% infill, no support
Turned out nicely. Unfortunately there were some issues regarding the lack of infill.
0
Reply
Print Profile
0.2mm layer, 0% infill, no support
Well, it works without support. but the other leaves is not that nice. p1s
0
Reply
Printed great with profile! Filament needed dryed tho.
0
Reply
Print Profile
0.2mm layer, 0% infill, no support
super fun, I will use different filament and see what kind of cool flowers I can make. thank you
0
Reply
Print Profile
0.2mm layer, 0% infill, no support
was really nice but a little bit stringing
0
Reply
Boosted
Thank you for the beautiful flower!
0
Reply
Boosted
Print Profile
0.2mm layer, 0% infill, no support
printed great. love it.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld