Small Spool Adapter
Remixed by
Copyright Claim
Small Spool Adapter
Remixed by
Boost
11
19
5
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
53 min
1 plate
Boost
11
19
5
0
40
41
Released
Description
With this adapter I was able to use smaller spools such as 250g and 200g - Although you definitely want to add weight in the middle of the spool holder. I used fishing sinkers and it worked. Thank you to “thenoob” for his work on the original spool holder! I printed out multiple spool holders and found this one to be the best, in regards to holding the spool and using less filament. I also printed in PETG.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Model printed well, but did not fit the adapter so it ended up being useless.
The designer has replied
0
Reply
It fit several of mine, especially the following;
IKSYSTEM
IWECOLOR
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed good, but doesn't fit any of my adapter reels
The designer has replied
0
Reply
It fit several of mine, especially the following;
IKSYSTEM
IWECOLOR
It stabilized the reel enough to be able to use and not continue to roll around. Sorry it didn't work on yours.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld