Fabric Tape Spooler | Soft Measuring Tape Holder
Remixed by
Copyright Claim
Fabric Tape Spooler | Soft Measuring Tape Holder
Remixed by
Boost
19
42
24
GIF
GIF
Print Profile(2)
Fabric Tape Spooler | 0.28mm layer, 2 walls, 10% infill
Designer
37 min
1 plate
Knurled Knob (Requested)
Designer
38 min
1 plate
Boost
19
42
24
5
94
81
Released
Description
The original by @noahrr was one of my favorites, but I found the winding holes too small for my fingers, so I remixed it with new easy to hold winding knob.
Prints easily and easy to assemble.
Comment & Rating (24)
All
Boosted
Print Profile
Knurled Knob (Requested)
Great profile - love the knurled knob, makes it easy to grip :)
The designer has replied
0
Reply
Loving the contrast between the silver/gray and the yellow. Thanks for sharing
0
Reply
Print Profile
Fabric Tape Spooler | 0.28mm layer, 2 walls, 10% infill
Printed great. Lid is a super tight fit so I struggled a bit to take the lid off when I put the tape in the wrong way, but it fits a full 60inch tape roll perfectly.
The designer has replied
0
Reply
Thanks for the feedback
0
Reply
Printed so nice! Top is nice & tight too! Thank you
The designer has replied
0
Reply
Looks great in red. Thanks for sharing!
0
Reply
Print Profile
Fabric Tape Spooler | 0.28mm layer, 2 walls, 10% infill
great file success on first try!
The designer has replied
0
Reply
Thanks for sharing your experience! 👍🏽
0
Reply
Print Profile
Fabric Tape Spooler | 0.28mm layer, 2 walls, 10% infill
nice print.in muy print,the top part does not fit perfect and the slot for the measuring tape is wider in the top and the tape gets all in if not careful, but its very nice
0
Reply
Print Profile
Knurled Knob (Requested)
The designer has replied
0
Reply
Nice looking! Thanks for posting a pic
(Edited)1
Reply
Boosted
Great design, work beautifully.
The designer has replied
0
Reply
Thanks!
0
Reply
Print Profile
Knurled Knob (Requested)
Really nice model, snapped in place, works perfectly!
The designer has replied
0
Reply
Thanks for the feedback!
0
Reply
Boosted
finally found one that works with my metal tab! thanks!
The designer has replied
0
Reply
Thanks for the feedback! Happy to hear that you were able to use it. 👍🏽
0
Reply
Print Profile
Knurled Knob (Requested)
Printed well. Hope there's a mechanism to easily pop the lid open.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld