Halloween bowl - Flower pot
Boost
88
140
14
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
Improved support - faster - 0.2mm layer, 2 walls, 4% infill
Designer
2.4 h
1 plate
Open in Bambu Studio
Boost
88
140
14
1
106
75
Released
Description
Pumpkin / Jack o lantern shaped Flower pot 6cm opening.
Can also be used as small candy bowls.
Comment & Rating (14)
All
Very fun and cool design for halloween
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support is difficult to remove
0
Reply
Nice design!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Struggling to get a solid print on the teeth hanging down, even with the tree supports. Multiple prints that failed each time :( Was very stringy on the tips
The designer has replied
0
Reply
Hi mate,
which printer and filament are you using? Does it fail as a spagetti failure or does the print complete with a bad finish of the teeth? is it the middle teeth in the top jaw you struggle with? and in regards of the struggles with support structure, is the problem that the support doesn't support the structure of the teeth well enough ?
if you give me a bit more information I'll try to replicate it and fix the issues you are experience.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Improved support - faster - 0.2mm layer, 2 walls, 4% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld