Creality Ender 3 V3 KE / SE - Blocks for Inserts by needitmakeit

needitmakeit

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

1.1 h

1 plate

5.0(1)

0.2mm layer, 6 walls, 35% infill

1.5 h

1 plate

5.0(1)

Boost

270

Released

Description

***DO NOT USE ANY OTHER PRINT PROFILES - THEY ARE NOT CORRECT**

Use these blocks to reinforce the base of the printer and also to position for accurate drilling of holes for making the printer more MOD-able

SPECIAL NOTE** It is a good idea to-pre-drill the blocks with a 4mm bit to clear the holes before gluing them into place. This makes it much less likely to tear the block off if the adhesive has not completely set.

To do this upgrade, I highly recommend you watch the video.

Printed from ABS

0.4N

6W/T/B

35% Cubic/Gyroid

Comment & Rating (8)

@FlyerDragon

Any alternative to ABS? I am not setup yet for ABS, and I only have my Ender 3 V3 KE

@user_2971725143

PETG is very heat tolerant like ABS, but dont need a heated chamber to print,.... just reduce cooling and print at middle of the heat range of the filament used

@user_4244780582

Hello and thank you for this mod. Can you also upload the rod holders for stabilization? Thank you.

(Edited)

The designer has replied

@needitmakeit

I'm just about finished that video and parts, I'm just in the process of testing them right now. I will upload when they're finished, it should be around 1 week or less. Thanks!