Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
1 plate
Boost
15
24
10
1
47
37
Released
Description
Stand for all Apple Watches.
Made from 2 pieces.
Have fun!
Comment & Rating (10)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
perfekt print
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Prints beautifully, but hole for watch charger is just a tad too large for the newer watch chargers when printed as is. Going to print again and enlarge just a tiny bit.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
prints nicely. quite large and bulky for such a small watch though. print is good quality
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The charger mount is not sung enough to hold the charger.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoDerivativesRelated Models
© 2024 MakerWorld