Good idea, I'll measure the bowl and do the cad and update the model!

lavernay

I loaded your STL in onshape and it appears it was drawn for a bowl with an opening of 175mm. Meaning a bowl that is 175mm where the bowl transitions to the flange (the flange is larger than 175mm) would fit in this stand if it were printed as is. Most slicers, including Bambu Studio have a scale option; my cat bowls are 125mm which is 71.4% of 175 so I scaled it to 71.4 in Bambu Studio and it printed perfectly.

Thanks again!

markcm

I thought about it again, be careful for the following points : 
-If you put water in a 3D printed bowl it will start to leak a bit in 3-5 days (depending of the wall thinckness, must be tested more)
-Since it's 3D printed bowl, depending of the material you printed it, it can release micro plastic particles that would go in the pet water/food.

Again these points has to be tested to be fully validated but I wanted to inform you.

Enjoy!

Was this drawn to fit a specific bowl? If so, could you link to the bowl? Thanks, neat design.

I had to do a big one and the paws at the back got stretched but it's 100% functional

wsantos

0.2mm layer, 2 walls, 15% infill,PLA,scaled for 125mm bowl

works very well!
even our „traditional“ food bowls fit into this riser.

It is a little low, so we would up the height next time.

Areolys

Printed perfectly and our cat loves it! thank you

Ranciid

We love this bowl riser for our cats! Thanks for the contribution.

colucci.pago

Brique2Designer

fyn7kdj6bz

cover

20231007_113614.jpg

20231007_113620.jpg

Capture.JPG

IMG_7313_97026776-10de-4c07-a02c-b39ea9c06b04.webp

IMG_7310_dc4a5001-a499-4dc5-b18b-3cb41d93ee6f.webp

IMG_7311_335ef4d4-2ddb-4eb0-b048-2ca02b855e94.webp

IMG_7312_124545c1-4b3e-40a1-adf2-f2c42ea21be4.webp

plate_1.png

<ul><li>Scaled for a bowl with 125mm diameter, measured where the bowl meets the top flange, this is equal to the diameter of the inner edge of the top of this model.<ul><li>Here is a link to the bowl I used https://www.amazon.com/dp/B0CB1B44FZ?</li></ul></li><li>Sliced at .2mm standard strength</li><li>PLA</li><li>Manual tree supports (they peeled right off for me)</li></ul><p>Note, the original STL of this file was scaled for a 175mm bowl (the flange of the bowl would be larger than 175mm). My file here is scaled 71.4% for my 125mm bowl, you can re-scale to what ever you like before printing. </p>

<p>Bowl holder for cats, or small dogs, with paws pattern in the back. Scale it up for big dogs!</p>

Print Profile(1)

Description

Comment & Rating (13)

License

Related Models

Free Pets Shelf - Mini

Chalice of Death and Beauty by AcmeArt

Modern Bonsai Pot Bowl

Minimalist Bonsai Pot Bowl

Pets bowl holder