Bambu Lab Build Plate Holder for Wall Mounted AMS
Copyright Claim
Bambu Lab Build Plate Holder for Wall Mounted AMS
Boost
9
18
4
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
5 h
2 plates
Boost
9
18
4
0
38
22
Released
Description
I mounted my AMS on the wall using cheap brackets from the hardware store.
https://www.obi.de/regalboeden-moebelbauplatten/obi-konsole-eris-weiss-300-mm-x-350-mm/p/8650608
With these slots, up to six build plates can be stored under the AMS to save space.
The small strip of double-sided adhesive tape is not necessary, but prevents possible slipping.
Removing the brim was a bit fiddly, but unfortunately without the brim I didn't have sufficient print bed adhesion.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
I’m sorry, this is unusable, & could cause damage to soft build plate finishes. the brim isn’t wide enough so you can’t peel it off it just becomes shreds. I used Bambu PLA, and there’s no way to cleanly get the brim out from between the slots. scraping at it with a razor blade and there’s still burrs between the fins and my deburring tools are too big to fit inside. sigh. it’s a nice model but I won’t risk damaging build plates. going in the trash.
(Edited)Other Issues:Could damage build plates inserted into it.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
it works
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld