Harry Potter cake topper
Copyright Claim
Harry Potter cake topper
Boost
36
79
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
36
79
10
0
64
36
Released
Description
Just cake topper i made from online picture i found…
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
print looked amazing until it started lifting, I will try again after I clean the bed. the design is great but it will not let me leave a higher rating since I cancelled the print once the lifting started.
(Edited)The designer has replied
0
Reply
you mean lifting... probably, you should learn more about 3d printing and how does 3d printer works.. probably issue between the printer and chair..
0
Reply
Replying to @8bwk2jp4gz
Jesus christ... what a stupid answer... at least give some hints or tips and reach a helping hand... NOT BLAME HIM! This is a community where we should help each other!
@linseysmom maybe try one of the following things:
1. regulate the temperature of the bed and also be aware that the room temperature should be as stable as possible!
2. try using adhesives (you can buy them online or at a 3D-printer-store next to you)
3. Change your slicer-settings (print slower, use brim/skirt/raft)
Hope it might help a little bit - otherwise use google - there are tons of forums where people already discussed some solutions!
Have a good print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Look nice.
Must only turn on the Brim but only outher and printed successfull
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
superbe
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld