X1 Carbon model 1:5 by Panda63

Panda63

Miniatures>Architecture

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

5 h

7 plates

4.8(51)

Boost

221

303

551

847

Released

Description

For all those who do not want to be without your X1C. You can take it to work, or on vacation or to the office.
The print head is movable.
Only the base needs support. All other parts can be printed without support.
The fan and the logos need a drop of glue to hold them.
I printed the case with silver colored PLA filament and it looks very nice.

Comment & Rating (67)

@Eri1

Print Profile

0.2mm layer, 2 walls, 15% infill

Perfect!!!

@slagle

Whoa, where did you get the AMS part? Would you mind sharing?

(Edited)

@Eri1

Replying to @slagle :

I sent you a PM

@menacekustoms

Replying to @Eri1 :

where did you get the AMS?

(Edited)

@williegarvin

Print Profile

0.2mm layer, 2 walls, 15% infill

Was happy to find this. Printed it in half size to fit in the kids "santa's helper" house, he moved in today Dec 1. It printed good enough even that small, the door was a little bit tough to get in, not surprising since it was so small. The logos didn't print this small though, they came apart in four pieces. The kids where thrilled and of course santa is using BL X1 as well :-)

(Edited)

@Jogi164

Print Profile

0.2mm layer, 2 walls, 15% infill

Klasse Modell, sehr detailiert. Der Druckkopf lässt sich sogar bewegen. Alle Teile haben sich problemlos drucken lassen. Den Deckel und die Türe habe ich mit transparentem Filament gedruckt. Das AMS habe ich auch noch dazu gedruckt.

@Eri1

hey! wo hast du das AMS her? LG

@Chrismeilak

Brillant Print! printed in Bambu silk silver pla and SUNLU transparent. thank you

(Edited)

@Juju7710

Print Profile

0.2mm layer, 2 walls, 15% infill

apart from some necessary improvements for the door (hinges too large) it’ s a wonderful design thanks !

@yanikld

Print Profile

0.2mm layer, 2 walls, 15% infill

frame in pla-cf Bambu, door in abs generic, "carbon" rods in pla-cf 3Dxtech, head in nylon and all other black parts in pla generic. I didn't care about drying my spools at all. temperature was 23 and hygrometer indicated 34%. excellent design with an excellent X1E!