Micro SD Card Holder
Copyright Claim
Micro SD Card Holder
Boost
48
95
53
Print Profile(2)
0.2mm layer, 2 walls, 100% infill
Designer
38 min
1 plate
0.24mm layer, 2 walls, 20% infill
38 min
1 plate
Boost
48
95
53
0
346
372
Released
Description
Ever forgot your Micro SD cards at home or in the other bag - or even worst - lost it because they are so small?
The Micro SD Card Holder allows you to protect and carry your cards always with you. The cylindric container (3,8 cm in diameter) can get unscrewed and holds up to 12 Micro SD Cards in the bottom shell. The cards are held by springs, so they do not fall out, even if you turn the bottom part upside down. At the same time the springs only cause gentle pressure - enough to hold the card, but not damage it.
Comment & Rating (53)
All
Print Profile
0.24mm layer, 2 walls, 20% infill
It doesn't screw well, but it gets the job done
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
nice make! need to figure out why my threads are a little chewed up, but they work fine. thanks!
0
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
unteres Teil perfekt
im oberen fehlerhafte Konstruktion am Gewinde
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
will need to print the top again at a slower speed but the bottom came out perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
(Edited)
0
Reply
really cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
would not screw on properly using pla+
0
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
The bottom part printed very well but the top part was a disaster, the thread did not print well at all.
0
Reply
Print Profile
0.24mm layer, 2 walls, 20% infill
This design is very good, the use of the internal tabs works much better than a normal friction fit. Very nice design!
0
Reply
啊，螺纹旋合有问题。建议修改简螺纹
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld