I installed my plate so it was slighty resting on the lip of the guide… So I wanted something to make it unlikely to repeat in the future.
These clips snap on and bring the height of table plate guides up just enough to make it easy to line up the plate, without getting in the way of the print head.
I printed mine in PETG so they would better handle the interior temperature of the enclosure, and use an extra fine 0.08mm layer height to make sure the guide edge is as smooth as possible while still allowing it to be printed laying down without support.
Quick print and easy to install, I hope you like them!
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.