Hueforge Stormtrooper Panorama
Krash 10
Shared by
Boost
42
62
12
Print Profile(1)
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
1.8 h
1 plate
Boost
42
62
12
0
79
29
Released
Description
Print at 100% infill and Ironing with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Bambu Sparkle Black Transmission Distance: 0.3
PLA PolyLite Steel Grey Transmission Distance: 1
PLA PolyLite Grey Transmission Distance: 1
PLA PolyLite White Transmission Distance: 5
Swap Instructions:
Start with Charcoal Black
At layer #7 (0.64mm) swap to Steel Grey
At layer #12 (1.04mm) swap to Grey
At layer #18 (1.52mm) swap to White for the rest.
Comment & Rating (12)
All
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
not too bad for a .6 nozzle and 2 year old non dried filament.
The designer has replied
1
Reply
looks good a little Heatgun kiss and these strings will also be gone 🙏
thanks for your vote
0
Reply
tres beau rendu merci
1
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
printed great.
1
Reply
this turned out great, not sure why, but the bottom layer printed and then the whole print shifted about 2mm from the base. I stopped it and restarted. it did the same thing. I just let it go and it turned out great.
0
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
The designer has replied
1
Reply
thanks for your voting 🙏
0
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
The designer has replied
0
Reply
thank you 😉🙏
0
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
0
Reply
Print Profile
0.6mm nozzle, 0.08mm layer, 1 walls, 100% infill
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld