Halloween Skeletal Witch Card

Halloween is here so I created this card! It opens very easily and also stays closed after opening and closing it a few times to soften the hinge part. Inside of the card is white and you can write your own text with a marker there. I recommend printing this on Textured PEI Plate because it makes the inner part look better and also easier to write on with a marker.

Printing instructions:

Filament swaps ONLY, no MMU or AMS required, but AMS makes it much easier.

Use Original HueForge profile to get the intended look, my models are very sensitive to print settings because of color blending between layers.
Every setting and filament changes for AMS are carefully prepared and fine-tuned in the Original HueForge print profile, feel free to change colors, but I recommend not to adjust other settings.
If you want to experiment with your own settings or non-original print profiles, for best look print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm.

First 4 layers have to be 0.2mm, use height range modifier from 0mm to 0.8mm with layer height set to 0.2mm.

Make sure the hinge part bridge direction slices as on the picture below, or the hinge might not work or even fall apart!

You can use same filaments as I did, or you can experiment with your own.

Don't forget to upload a make!

Filaments Used:

• PLA BambuLab Basic Black Transmission Distance: 0.6
• PLA BambuLab Basic Blue Gray Transmission Distance: 3
• PLA PolyTerra Sunrise Orange Transmission Distance: 2
• PLA BambuLab Basic Jade White Transmission Distance: 4

Swap Instructions:

• Start with Jade White
• At layer #3 (0.6mm) swap to Black
• At layer #7 (0.92mm) swap to Blue Gray
• At layer #13 (1.16mm) swap to Sunrise Orange
• At layer #26 (1.68mm) swap to Jade White for the rest.