This is a simple stand designed for holding small models - in our case - split body kyber crystals. This is a simple print and completes in under an hour. The pegs are just offset to the main body and are half the diameter of the peg holes. You can either double up the pegs or save a few as spare and use them in half.

A small dab of super glue will hole them in place. Allow to cure and they are plenty strong to hold items while painting. Printed at 5% infill and designed to use minimal motion and filament assuming you orient properly.

Print Settings

Rafts:

No

Supports:

No

Resolution:

.28

Infill:

5

Notes:

Set print to use linear lines and infill. This will minimize print time even further. Personal best is 37 minutes on our CR6-SE