iPhone Magsafe Charger With Apple Watch Remixed by Miniature Makes

Remixed by

Miniature Makes

Tools>Gadgets

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2 h

1 plate

4.6(14)

Boost

Released

Description

MagSafe charger for iPhone with additional charger for the Apple Watch. Prints without supports

Comment & Rating (17)

@3D_Print_DE

Print Profile

0.2mm layer, 3 walls, 15% infill

Perfect fit 👌🏽

(Edited)

@Bearmun

Boosted

Love the model

@meCoreyG

Print Profile

0.2mm layer, 3 walls, 15% infill

while this is nice and good quality. it is not IPhone Standby Mode compatible with the Apple Watch. meaning you cannot have your phone (iPhone 14 pro max) sideways and the watch charging at the same time. if we can get this feature I will reprint and use as my main stand at night.

@guillaume76620

Print Profile

0.2mm layer, 3 walls, 15% infill

good job for my charger ! good job thx !

@VRarts

Print Profile

0.2mm layer, 3 walls, 15% infill

very nice

(Edited)

@gicalgary

Print Profile

0.2mm layer, 3 walls, 15% infill

The print is great, but I found that the base on the model was too short, and the stand falls over if you only charge a watch.

(Edited)

@thevoices

I really wanted to this work, just cant the puck for apple watch... original USB-A version wont fit in with out trimming inside... but the more serious issue is the bend near the buck is too much. I have tried to see if its possible to add layers "very newbie" to the bottom ... to give the cable not such a bad bend and allow the cables to rest in the channels. Sadly I printed a second time before I realized it didnt and actually tried 2 other designs that also didnt work properly. I really like this with Iphone above.