Scotch Brand Packing Tape Dispenser replacement w/ metal cutter by makernaut

makernaut

Household>Office

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.3 h

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

This remix only works with a scotch tape dispenser blade with 4 holes in the metal-- the outer two holes being 48mm apart.
Mine broke and i wanted to recycle the blade. This is your solution in that specific case!

You will need 2 >5mm long M2 screws to retain the metal blade. You will need to cut some more plastic off the new body after printing to make the blade fit, if it doesn't

to print, orient with flat facing down and add supports for the upper tongue.

remove the metal blade from the original scotch tape dispenser by cutting the plastic retaining bits off of the body and yoinking it off.

Comment & Rating (2)

@Quantum.Grower

Print Profile

0.2mm layer, 2 walls, 15% infill

Great model and print profile 👌🏻

@Quantum.Grower

Nice model! It seems pretty flexible so I'm not sure the durability yet. My blade from the HDX dispenser is slightly too large, but I was able to cut a bit off each end with tin snips. Now i just need to find some M2 screws (which I dont think I have, so this might be more costly than anticipated lol). Thank you. EDIT: Found 1 screw from an M.2 SSD I had kicking around 😆 EDIT 2: My tape roll is too thick for this dispenser. DUCK Tape brand tape.

(Edited)