USB, SD and Micro SD card storage holder for HSW
Remixed by
Copyright Claim
USB, SD and Micro SD card storage holder for HSW
Remixed by
Boost
10
30
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Boost
10
30
6
0
55
36
Released
Description
I liked the original model but I don't need as many slots so I cut it in approximately half.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
works god
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed good in PETG as I had some leftover. a little ragged but I think my filament was just wet. hole sizing is perfect for the USB and SD cards nice firm fit. Not sloppy.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld