Clean Dirty Dishwasher sign
sledutah
Shared by
Copyright Claim
Clean Dirty Dishwasher sign
sledutah
Shared by
Boost
46
86
39
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
12.4 h
2 plates
Open in Bambu Studio
Boost
46
86
39
3
217
232
Released
Description
I seen this design and had to paint and print! Please give the creator some love!
Comment & Rating (39)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
It fits nicely onto the other part to go with this. Now, I did have an issue printing it, but I think it’s my fault. My printer is having issues with changing colors. I plan on cleaning my printer and see if that helps
(Edited)
0
Reply
I feel like maybe the filament is on too high of temp.
0
Reply
Replying to @3Dcreative4
thanks, I had just started 3d printing when I printed this.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great print, came out really nice!
I opted to print the sliding dishes part flat down on the bed with supports underneath - to avoid so many filament swaps and make for a faster print - The supports printed in same material came off cleanly(also the supported surface is mainly hidden when assembled, so no issues if it didn't)
1
Reply
Printed really well. I made a few mods like taking the front knobs off so the dishes would print flat and have a clean surface. also made end caps so the dishes would not slide off. Thanks!!
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great design! This was also a great way to use up some of my last green filament in a useful print.
(Edited)
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Great print. I bumped the quality up to .08mm extra fine on my P1S and turned on ironing. I also rotated the Dishes slider so that it printed face up. Yes, it adds a bit of support material, but it also finished in about 2 hours vs the 26 it would have been on its side.
0
Reply
Boosted
Print Profile
0.2mm layer, 6 walls, 25% infill
Nice print however the sliding cover is missing the tab to keep it from coming off when slid to the left. I placed a bead of glue in the “V” channel on the bottom to stop it.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Came out beautifully.
It would benefit from a stopper to keep the slider from flying off.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
what tipe of magnets do you need to use?
The designer has replied
0
Reply
8 - 6x2mm magnets
0
Reply
can you make the dishes thing on its side not straight up I think it wil take up less time and use less filiment.
0
Reply
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld