Search models, users, collections, and posts
Basic Soap Holder
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
3
7
1
1
8
5
Released
Description
This is a basic soap holder. It was printed at 150%. This will fit most if not all bars of soap.
The Purple one was printed with PETG, while the Blue one was printed in PLA.
My software asked for supports, but I don't think they're needed.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)