Halloween Pumpkins
fabricke
Shared by
Copyright Claim
Halloween Pumpkins
fabricke
Shared by
Boost
62
115
56
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
2.4 h
1 plate
0.12mm layer, 2 walls, 15% infill
17.3 h
3 plates
Boost
62
115
56
0
453
393
Released
Description
This is a Halloween 3 Pumpkins printing set wich has a 28mm hole in the Bottom to adapt a LED candle.
The LED I use are those (is just a personal choice):
http://www.ebay.de/itm/16-Stk-LED-Teelicht-Flammenlose-Elektrische-Teelichter-Kerze-mit-Batterie-/400585657588?hash=item5d44c40cf4:m:meWLhUp0o8jhSeDWoniPaqg.
Designed using Rhinoceros+Grasshopper and printed with an Ultimaker Original +
Hope you like it and enjoy Halloween!!
Comment & Rating (56)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
A bit too much infill I think.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
these came out really well. I drilled a hole through the stem to make floating pumpkins.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed verry small to give for presents
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
there are some artifacts at the top from the profile's monotonic top layer setting.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A design of 10, it prints very well. I didn't have to touch any parameters, everything is perfect!!!!
0
Reply
A 10 design, prints very well.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Happy Halloween
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
This printed out perfectly. Thank you for your design.
(Edited)0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
I need to create suport on the mouth
0
Reply
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld