#1 Dad LowPoly Trophy Remixed by marekzeman91

Remixed by

marekzeman91

Art>Other Art Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.16mm layer, 2 walls, 15% infill

Designer

4 h

2 plates

5.0(6)

A1: 0.16mm layer, 2 walls, 15% infill

Designer

5.5 h

2 plates

3.7(3)

Open in Bambu Studio

Boost

107

113

Released

Description

Simple yet cool trophy for your number 1 dad.

Comment & Rating (12)

@Dport_mini_A_3D

Print Profile

A1: 0.16mm layer, 2 walls, 15% infill

I have tried 3 times to print this trophy 3 times it has failed. the top of the trophy gets knocked off the base just above the side handles and then it air prints. my son has tried this too and wanted to give it to me for father's day. but he could not get it to print. it brought him to tears. so I tried. recalibration done. new pla. nope none of it worked. I even set alarms to watch this one and at 86% it was good but 90% it failed. yuggg. nice design though. what am I doing wrong?

The designer has replied

@marekzeman91

No idea. I’ll try to print it on A1 to see if it works for me.

@zemistr

Boosted

Is that a silk filament? I've had similar problems with silk filament and fast printing. Try raising the temperature, slowing down the print or trying a different filament.

@marekzeman91

I am sorry that it didn’t work well for you. It looks like the A1 wiggles a bit and the head kicks the goblet down. Try to tighten all the screws and print on half speed. Move the goblet to the top right corner as close as possible to hopefully prevent the wiggle knock.