Simple mounting collar for an E3D hotend to a basic Delta effector. This extends out the side and allows the mounting of a Berd-Air Cooling tube for part cooling.

There are slots to add nuts for the bolts to attach the opposite side.

You'll need a couple of other parts to complete the mount:

2 - 3x14mm or 3x16mm bolts
2 - 3mm hex nuts or square nuts
Berd-Air Cooling tube

*Optional but HIGHLY recommended: V6 Silicon Sock.

Print instructions

Shouldn't require any supports.

Print out of a 'mechanical' filament (PETG, ASA, Nylon, etc).

Print External Perimeters to internal to preserve tolerances.

DO NOT OVER-TIGHTEN THE CLAMP ON TO THE TUBE! You will crush it.