Garmin Charge Port Protector
Copyright Claim
Garmin Charge Port Protector
Boost
17
26
4
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
24 min
1 plate
Boost
17
26
4
0
23
15
Released
Description
TPU Cover to protect the contacts for compatible Garmin watches. Tested on Fenxi 5 and 7, and also VivoActive. Protects the sensitive contact pins against corrosion caused by skin contact and residual acids. Prolongs the life of the charge contact pins. Does not seal watertight, so please remove and dry off pins after being in water or sweating profusely. Have been using this design on my Garming watches for three years without any issues. Has a little tab to asisst in removing from the charging port. TIP: Print in bright color TPU so you can see them is they lie around!
Comment & Rating (4)
All
Print Profile
0.08mm layer, 2 walls, 15% infill
It's a bit too high for my Epix 2 Pro. So the cover is not flush with the back of the watch. I scaled the height down a bit, it now fits well. Thanks
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld