I designed this wall mount for a HT DN50 pipe to have enough space to the wall to fit a 100 mm Blast-Gate.

The mount goes on the bushing side of the pipe. If you want to mount on the pipe diameter i also uploaded a thicker clamp(Schelle_HT_DN50_Rohr.stl).

I used two standard M4 Threaded Inserts from CNC Kitchen(https://www.printables.com/model/482734-threaded-inserts-heat-set-inserts-by-cnc-kitchen) in the main body.

The clamp is screwed on with two DIN 912 M4x16 screws

Filament: extrudr greentec pro (PETG should also be fine)

Print settings:

• orientation: see picture
• layer height: 0.2
• wall loops: 6
• Top/bottom layers: 5
• infill: 30% gyroid
• support: no