Bambu X1C/P1P Poop Cover Flat (No Logo)
Remixed by
Copyright Claim
Bambu X1C/P1P Poop Cover Flat (No Logo)
Remixed by
Boost
9
17
9
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
19 min
1 plate
Boost
9
17
9
0
35
26
Released
Description
There's a big gap between the poop chute and the interior volume wall. If you look from the side, you can directly see the electronics, meaning that hot air from the printing volume will go to the electronics and also cooling air from the electronics might easily get to the printing volume. This amazing design will close that air to try and remain both zones more separated!
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 20% infill
excellent print fits perfectly. Added the BL logo
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
bella stampa e perfetto aggancio
0
Reply
Great model. Printed in ABS
0
Reply
Pardon my ignorance, but doesn't the slot where the z leadscrew is in the back pass straight to the electronics? On my x1c, I can put my hand from that slot and my fingers come out the hole this covers. I'm wondering if there's a preventative for that or if it's futile.
1
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
A very tight fit which took some attempts to get in, but it works very well!
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld