Suspended 1 (Skull) by FallenAngel

FallenAngel

Household>Decor

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

Multi color, 0.3mm layer, 2 walls, 15% infill

Designer

9.6 h

1 plate

5.0(10)

0.3mm layer, 2 walls, 15% infill

Designer

4.8 h

1 plate

4.7(9)

Boost

121

239

Released

Description

Suspended Skull based on string technique.

Comment & Rating (34)

@marcoturla

Print Profile

Multi color, 0.3mm layer, 2 walls, 15% infill

Dual Color works perfect. Thank you!

The designer has replied

@FallenAngel

Thanks for the feedback.

@FangSterling

Print Profile

Multi color, 0.3mm layer, 2 walls, 15% infill

printed great with no need for any other configurations

The designer has replied

@FallenAngel

Thanks for the feedback

@TestLab80

Print Profile

0.3mm layer, 2 walls, 15% infill

Came out nice. A few small errors on the print but it was my printers fault. thank you.

The designer has replied

@FallenAngel

@TestLab80 looks so cool. thank you.

@marlagarrison11

Great String Art! Love this! I printed with Black/orange PLA.

The designer has replied

@FallenAngel

@marlagarrison11 ! looks so nice. Thanks

@andrew93752

@jmc71479

Print Profile

0.3mm layer, 2 walls, 15% infill

@Bretthtml

Print Profile

0.3mm layer, 2 walls, 15% infill

Cool idea. but unfortunately had to stop the print. Nice model but current settings and the infill that is used on this profile when traveling it drags on the infill and is just asking for a bent nozzle. edit. I didn't change any settings use the bamboo handy app The only thing that was different was it was silk PLA that was used which obviously could be the problem with the dragging on the infill due to swelling but other than that I used your settings through the handy app.

(Edited)

The designer has replied

@FallenAngel

I printed couple of them without any issues ( Single color) bro. Maybe u made some changes to the file. U can also see successful prints from other users too.

@Bretthtml

no settings were changed. was printed through bambu handy app using generic silk BLA and possibly that could be the reason was due to swelling I'm assuming you did not use silk. but use the provided settings and was just reporting my experience. I'm sure my results would be different using regular PLA.

(Edited)

@FallenAngel

Replying to @Bretthtml :

In case if you use Silk, U need to switch off the fans as they tend to suck/blow them. But I am not sure if this fixes the issue 100%. Also its unfair to rate low because of your selection of filament. Maybe I should have mentioned that its not for Silk filament.