The original pin of the wooden spinning top broke, and with no replacement parts available, I designed an exact replica to continue using it.

Print Info:

It should be printed standing up, with the tip pointing upwards. When printed in this orientation, it is prone to breaking along the layer lines. That's why I used PETG and a rather high print temperature of 255°C to improve layer-to-layer adhesion. A brim is necessary but will (usually) be generated automatically.

In Bambu Studio:

• Material: PETG (or PLA for lower durability with better looks)
• Profile: 0.08mm Extra Fine
• Wall Generator: Arachne (for adaptive layer width)
• Wall Loops: 5
• Support: None