Bambulab Rear Exhaust Device

This is an exhaust model that helped the Bambulab 3D printer.

When you need to print ABS, carbon fiber, and other materials, although the machine will have a filtration system, but as far as we personally use, there will still be a relatively heavy odor, I hope that such a device can help you discharge harmful gases out of the room or filter them again.

This device is recommended to be equipped with a 50mm exhaust pipe, it is not recommended to use a large caliber, such as 110/150mm, and the wind is not recommended to be too large, so that the space on the back can be fully utilized without affecting the aesthetics. The left and right screws can use the screws that come with the Bambulab printer.

If you use PLA material, do not tighten the screws too hard, if you use ABS and PETG materials, you can tighten the screws a little harder. Hope everyone has a good time for printing!