NASA Meatball Logo
Copyright Claim
NASA Meatball Logo
Boost
57
96
27
Print Profile(2)
0.2mm layer, 2 walls, 50% infill
Designer
8.8 h
1 plate
Smaller version - 0.2mm layer, 2 walls, 10% infill
1.8 h
1 plate
Boost
57
96
27
0
185
111
Released
Description
make sure to disable the aux fan, the part is too close.
you can purchase one here
https://www.ebay.com/itm/115660839209
Comment & Rating (27)
All
Print Profile
Smaller version - 0.2mm layer, 2 walls, 10% infill
Awesome print
1
Reply
Print Profile
Smaller version - 0.2mm layer, 2 walls, 10% infill
My son printed the full-size version and I was jealous so I printed myself the coaster version to display on my desk. I love it! A great model that printed beautifully!
1
Reply
Print Profile
Smaller version - 0.2mm layer, 2 walls, 10% infill
Sehr saubere Oberfläche
1
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Printed perfectly. Looks great next to my Lego Saturn V.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
Overall, this turned out amazing! I printed it for my son and he loves it. a close inspection shows a slight layer shift on the red portions that overhang, I think they lifted a bit about 3/4 through the print. it’s possible this also contributed to the top surface being not the best. thankfully it’s only noticeable when you look closely. I’m going to print a small version for myself now!
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
It's near perfect. White has some bleed through but barely noticeable.
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 50% infill
0
Reply
Print Profile
Smaller version - 0.2mm layer, 2 walls, 10% infill
definitely remember to keep aux fan off, even for this smaller version. great model! I’m going to turn mine into a fridge magnet
2
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld