Mark Rober 3/4 Scale Nerf Blaster
Remixed by
Copyright Claim
Mark Rober 3/4 Scale Nerf Blaster
Remixed by
Boost
13
13
19
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
2.3 h
2 plates
0.16mm layer, 4 walls, 100% infill
2.6 h
1 plate
Open in Bambu Studio
Boost
13
13
19
0
67
111
Released
Description
Mark Rober's Compliant Nerf Gun
Comment & Rating (19)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Unfortunetly no success. Already 5 times tested.
I wil use 3DLAC and hope it will work. This rating is only for the ammunation. The Nerfblaster works fine
(Edited)
0
Reply
what are you using for adhesive on your bed ?
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
it printed good
Strength Issue
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Great print no issues at all and works perfectly.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Turned out well
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
would stick and ended up with only half the print
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Bed Adhesion Issue
0
Reply
Print Profile
0.16mm layer, 4 walls, 100% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld