Search models, users, collections, and posts
Skip and throw
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.5 h
3 plates
Open in Bambu Studio
Boost
9
35
0
0
13
4
Released
Description
The goal of this game is to end up with as few pins as possible. You can only move by jumping over nearby pins in which case you remove the pin which was jumped over.
Pins are double coloured so you will need to change filament four times throughout printing (in case you use gcode).
I added a version with 33 positions as the original version of the game. “V1”
Boost Me (for free)
Thank you for supporting my work.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)