ESP32 Dev board Case
bkgoodman
Shared by
Copyright Claim
ESP32 Dev board Case
bkgoodman
Shared by
Boost
11
19
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
30 min
1 plate
Boost
11
19
12
0
44
48
Released
Description
Case with Snap-on lid. Lid has detents for buttons. Case has cutouts for USB, LEDs and pins will stick out of back of case.
If you want a version of this case where the pins are fully shelled/enclosed - see: https://www.prusaprinters.org/prints/50035-esp32-devkit-v1-chunky-case
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Fit perfectly on my ESP32. The built in buttons click perfectly with the board.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A very clean design.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Print came out great, but it was not the right one for my board. That's on me.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Any reason for 3 stars?
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
The user shared this model, but is not the original creator of it.
License
This user content is licensed under a
Creative Commons Public Domain
© 2024 MakerWorld