Card for AirTag by MaroDavide

MaroDavide

Tools>Gadgets

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

33 min

1 plate

3.9(33)

Boost

101

145

Released

Description

This is a simple holder for AirTags to insert in the wallet.

The card is only 3mm thick so as not to cause particular discomfort.

If you want to support me: Thanks

Comment & Rating (41)

@patridge

Print Profile

0.2mm layer, 2 walls, 15% infill

Not sure what went wrong, but I had my first A1 mini print failure on this one. Prints before and after have all worked fine. 🤷‍♂️ Ended up using a slightly different AirTag card model successfully.

The designer has replied

@user_4161259174

clean your heat plate with soap and water and possibly consider using a glue stick on the plate

(Edited)

@lukas.duus

@patridge why give him 2 stars, when your failure has nothing to do with the model itself?

(Edited)

@MaroDavide

Replying to @lukas.duus :

thanks @lukas.duus

@DU43D

Print Profile

0.2mm layer, 2 walls, 15% infill

👍

@ted1ba1r

Print Profile

0.2mm layer, 2 walls, 15% infill

Nice design and strong. AirTag is a tight fit but once it’s in you know it’s not going to fall out.

@tekki86

Print Profile

0.2mm layer, 2 walls, 15% infill

@wwwjscom

Print Profile

0.2mm layer, 2 walls, 15% infill

a little tight but putting it on a table and pushing forced the AirTag in.

@fivesaw77

Printed in PETG on A1, default settings, deburred and works perfectly.

@Shauberg

Print Profile

0.2mm layer, 2 walls, 15% infill

printed quickly, tag pops in and out easily. perfect for when the battery needs changed.

@shelbycapcor

Good tip on using the deburring tool. I made these some time ago and was frustrated the AirTag would not fit. A couple of passes with the deburring tool did the trick. Thanks!

@robertdelage

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed in PETG, a bit thight needing to use a deburring tool to ease on one side to force fit the AirTag. On the bright side, it hold the AT like a charm. Great design!

@klaus.petersen

..passt bei mit (Bambulab P1P) nicht. Ich wollte auch keine Gewalt verwenden, aber das Loch ist definitv zu klein Vielleicht gibt es vom Airtag verschiedene Versionen?