Simple Chess Pieces
Copyright Claim
Simple Chess Pieces
Boost
20
50
22
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
20
50
22
0
193
205
Released
Description
This is a simple chess set designed on TinkerCAD. The crown on the King and the Knight need a little support.
Comment & Rating (22)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great in Matte PLA. only issue I had was the King’s cross is a little delicate but that should be expected
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
came out good takes about 3 hours and you got a full chess set
The designer has replied
1
Reply
thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works very well
The designer has replied
0
Reply
thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
worked great
The designer has replied
0
Reply
thx
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Be careful pulling off the plate, pieces break easy. Kings cross looked funky
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld