4 way overhang test by ilikeapples12

ilikeapples12

3D Printer>Test Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

Std. settings, 0.2mm layer, 2 walls, 15% infill

49 min

1 plate

3.8(38)

Open in Bambu Studio

Boost

433

224

Released

Description

this version has thicker towers and shallower numbers to make it more representative of real printing conditions

prints in about 1h30m and weights 10g

the circle in the base marks the front

test

overhang

test print

Comment & Rating (38)

@cagriahiskali

Print Profile

Std. settings, 0.2mm layer, 2 walls, 15% infill

Good test part.

@Phenix

Print Profile

Std. settings, 0.2mm layer, 2 walls, 15% infill

tested my esun dual color silk Pla. worked fine. looks perfect up to 50 on all sides. just wonder if the aux fan had any effect

@tpanciroli

Print Profile

Std. settings, 0.2mm layer, 2 walls, 15% infill

base is too small. and it knocks the print off the bed

@ganix

Print Profile

Std. settings, 0.2mm layer, 2 walls, 15% infill

Bed Adhesion Issue:The model isn’t the big problem, it’s the bed adhesion. I printed it three times and every time at about 60 degrees the model fell over. I also had some stringing at the bottom.

@warmup

Print Profile

Std. settings, 0.2mm layer, 2 walls, 15% infill

Design works as it's supposed to, MW doesn't allow me to rate it 5/5 without a successful print though. A constructive criticism, there could be a model w a wider base for better adhesion so that the nozzle doesn't knock it at the easiest problem. This would be more realistic as a real world test as when you get overhang problems, your print will most likely not get unstuck and will continue w bad quality